Wood Preservation Methods
The study of wood as a renewable material and organic material is what is known as wood science. The processes and the tools used to utilize the material is what is known as wood technology. Other products are put alongside wood for easy testing and study. The wood is checked against the other materials properties, performances, value, and work-ability. The many Merits of timber and these technologies improve wood to be superior over other products. The wide range of products where wood can be used is just one of the many advantages that give wood an upper hand over other products. Once a tree has been cut down another can be planted in the same spot. All the parts of wood can be put into use, and this makes it a better fit than other materials which most of their byproducts are a waste.
The good appearance of your timber made structure cannot be guaranteed if protection of the timber is not done. Wooden structures have to be kept away from water and pests that eat through the wood. The rotting and decay of the timber products are caused by the moisture and the insects. There are many ways timber is treated among them being the ACQ in other words alkaline copper Quaternary. As the name implies the preservative is made of copper products. There are a few disadvantages of this method as a mode of wood preservation. The chemical is highly corrosive to most metals, the chemical corrodes away galvanized fasteners and therefore only stainless steel is used. The species of the wood and the application of the wood will determine how many chemicals will be used on the wood. The level of chemical concentration will be determined by where the piece of wood is going to be put to use.
The use of copper metal is another method of wood treatment that is fast being accepted. The use of this method is fast being accepted because it is not corroding the metal fasteners. This process is what in other words called the micronized copper wood preservative. In this process microscopic particles of solid copper metal are mixed in a liquid carrier and injected to the wood at high pressure. The difference between this method and the other copper-based methods is that the copper is used as a metal rather than a dissolved material. The characteristics of the wood are highly improved and the when this process is used to treat wood. The timber treated in this way is used in both outdoor and indoor frames that last very long.
The micronized copper preservative has proven to be highly effective in protecting the wood against fungal decay and termites. It has also shown to be an improvement in corrosion resistant properties to metal fasteners. When you use this method to treat wood, then you will not need to worry for at least ten years.